Rear Panel (Right or Left-side)
1.
Measure the distance from the top of the bench seat
to the top edge of the back panel. Cut the rear
panel to this length.
2.
Measure the distance between the shower base and
the bottom of the bench seat. Again, cut a piece
from the rear panel.
The Swanstone panels have finished outside edges.
Make the second cut in the same area as the first cut.
3.
Dry fit the rear panels, and make any necessary
adjustments. Scribe and cut both rear panels to fit
the back wall, or use the corner molding supplied in
the kit.
Panel Installation
Fumes Hazard
The fumes from the sealants and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area.
1.
Clean the backs of each panel with denatured
alcohol or another non oil-based cleaning solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
2.
Apply the silicone in 1-1/4” diameter dots every 8 to
10 inches apart over the surface of the panel.
Follow the silicone manufacturers’ instructions and
note all ventilation and installation precautions.
BK-PI-002b
IMPORTANT NOTICE
BK-PI-001
WARNING
BK-RP-002
IMPORTANT NOTICE
BK-RP-001
1
2
800-325-7008
19
The Swan Corporation – Swanstone
Installation Procedure
