1. The main characteristic:
1) Stereo output 75W/4
Ω×
2(RMS)
2) 1/4" phone Jack (front panel)
3) 4 channels MIC input XLR connector
4) Stereo (CD/ tape) input with level control (front panel), 1/4" input phone Jack
Once the stereo signal connects the microphone, it will automatically cut off
the signal
5) Every channel with treble and bass volume control reverberation and level
control
6) The main volume in the front panel
7) Inside reverberation effect
8) Inside DSP effect / Digital delay
9) Inside power supply with switch
10) Five band diagrammatic equalizer with sound feedback monitor
11) Good 60 mm course attenuator and enclosed regulation resistance
2. Characteristic:
10" two pass filter
Power
：
100W
Impedance
：
4Ohm
Frequency Response
：
60Hz-20KHz
Sensitivity
：
94dB
Crossover frequency
：
4KHz
output power: 75W/4
Ω×
2
Frequency Response: 20Hz-20KHz
≤
1dB
THD: 20Hz-20KHz
≤
0.1%
Equivalent input noise level:
≤
-114dB
Channel equalizer: alt:
±
15dB
Bass:
±
15dB
Power supply: 120VAC, 60Hz 200VA
230VAC, 50Hz 200VA
3. The main technical parameter:
4
1
7. setting installation
(1) After turning on the power supply, turn up the main
channel slowly. The best effect is at 6 positions.
(2) Set the level for well connected channel (channel 1
is MIC. Channel 2 is guitar. Channel 3 is C
D player)
(3) Adjust the gain attenuator in every channel
(4)Change tone in every channel by 2 band equalizer
(5) Clockwise whirl can increase the sound-surroun d
ambiance of the tone. it will be decreased in anticlo-
ckwise direction
0
5
10
REVERB
-10
0
+10
TREBLE
-10
0
+10
BASS
10
9
8
7
6
5
4
3
2
1
0
GAIN
CHANNEL 1
·
Adjustable diagrammatic equalizer
(1) Mixer with 5 band diagrammatic equalizer
(2) Adjust the main track tone balance after organ-
izing the signal in all channels.
(3) Increase or attenuate 12 d B in every equalizer
(4) Move the slide bars to
“
+
”
direction to increase
the signal in the frequency range. Otherwise it
is attenuation. In this way it can decrease th e
feedback from the different frequency range.
+12
+6
0
-6
-12
+12
+6
0
-6
-12
LOW LOW/MID MID HIGH/MID HIGH
(1) After finishing the above installation you can turn on the power supply
(2) make sure the mixer power supply is in closed state before you turn on the
power supply
(3) Connect the standard IEC power supply plug to the socket in the wall and
also connect the power supply
(4) make sure that all of the attenuator gain is at the smallest position ( every
channel including the main channel)
(5) Turn on the power supply switch at the back of the mixer.
·
Connect the power supply
