14
Tube Facing Tool
User’s Manual
Operation
The tool should only be operated using a ground fault circuit
interrupt (GFCI) protected outlet.
Adjusting for Tube Size
The TF72 series can be adjusted using the tube clamp
adjustment dial to compensate for variations in tube tolerances.
The adjustment dial has three marks: • (the factory setting), +,
and -.
The adjustment options are as follows:
Tube size is
nominal
Tube size is
smaller than
nominal
Tube size is
larger than
nominal
Position of tube
clamp
Position of the
tube clamp is
correct.
The tube clamp
rests on the
tool frame and
will not clamp
tube.
The tube
clamp cannot
be lowered.
Adjustment
required
towards:
•
-
+
1. Lift the tube clamp and remove the tube, if necessary.
2. Loosen the socket screw on the tube clamp adjustment dial
using the provided 4 mm T-handle hex key.
3. Turn the tube clamp adjustment dial in the needed direction.
Allow the pin the engage into the adjustment dial.
4. Tighten the socket screw on the tube clamp adjustment dial
using the provided 4 mm T-handle hex key.
Fig 13 Loosening the Socket Screw
Fig 12 Tube Clamp Adjustment Dial
