Translations available on
www.swagelok.com
.
Swagelok — TM Swagelok Company
© 2011-2020 Swagelok Company
August 2020, RevB
MS-CRD-0190
4. Turn the vise handle clockwise to close the vise until
the jaws just hold the hose in place. Turn the handle an
additional 1/4 to 1/2 turn to secure the hose.
Note: If the hose still moves, repeat steps 3 and 4,
tightening the vise handle until the hose is secure.
5. Insert the first barb of the end connection into the hose.
6. Lower the pusher handle until the mandrel meets the end
connection.
7. Hold the hose in line with the end connection and lower
the pusher handle to push the end connection into
the hose until the end connection is inserted properly
according to the table below.
CAUTION
There is a potential pinch point between the end
of the hose and the divider tab.
Hose Type
Insertion Criteria
Rubber
Hose seats flush with the
divider tab
Nylon and Polyethylene
Bottom of the insertion mark
lines up with the edge of the
end connection.
If the hose is not properly inserted, open the jaws, and
repeat
Insertion of End Connection onto Hose
steps 3, 4,
6, and 7.
8. Raise the pusher handle and open the jaws to remove the
hose.
Note: The recommended method is to fully open the jaws
and unload from the top. Larger hose sizes will
have to be pulled through the jaws to be removed.
Replaceable Component
Ordering Number
Push-On tool
MS-SPOT
Mandrel kit
MS-SPOT-MKIT
Jaws
MS-SPOT-JAW-KIT
Lubricant
MS-TP-LUBE