Preparation
1. Use six 3/8 in. bolts or a clamp to attach the tool to a
workbench. (Bolts and clamp are not provided).
2. Line up the flats of the vise handle to the tool and push
the handle on until it stops. Thread the set screw into the
handle and tighten with a 1/8 in. hex key.
3. Inspect the tool and jaws for wear. Replace the jaws if
excessive wear is observed. (The jaws will be rough to
the touch.)
4. Lubricate the tool shaft in the locations shown with the
provided lubricant prior to initial use and approximately
every 500 assemblies or once per week. Cycle the
handle several times after applying the lubricant.
5. Select the appropriate mandrel according to the table.
Hose Type
Nominal Hose Size,
in.
Recommended
Mandrel Size
Rubber
1/4, 3/8, 1/2
Long
3/4
Medium
1
Short
Nylon and
Polyethylene
1/4, 3/8
Long
1/2
Medium
3/4, 1
Short
6. For assemblies using tube fitting end connections (-SL
and -SM designators), verify that the nut and ferrules are
installed prior to pushing the end connection onto the
hose. Install if necessary.
Nuts and Ferrules
Nuts and Ferrules
Not
Installed
Installed
7. Place the pusher handle in the down position.
8. Verify that the limiting spring is installed.
9. Thread the selected mandrel into the end of the pusher
fingertight.
Note: The short mandrel is installed at the factory.
Remove it from the pusher if a different size is
needed.
Mandrel
Pusher
Limiting
spring
Apply lubricant here.