SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
25000L
BED
IENUN
GS
AN
LEI
TUNG /
INSTRUC
TI
ON MANU
AL
OPERATION
Always use suitable paint/varnish. Before you start your operation, check the instructions of the
manufacturer.
1. Fill the desired amount of paint into the cup (#
1
).
2. Prepare the work piece carefully. Clean it
– traces of dust and grease will seriously affect the
result. Cover or mask everything, which is not meant to be painted.
3. Pull the trigger and start your operation. Keep in mind to always keep a distance of
15
– 20 cm between the nozzle and the work piece.
ADJUSTING THE AMOUNT OF PAINT
You can adjust the amount of sprayed paint in accordance to the surface of the work piece.
Turn the paint regulator (#
2
) clockwise to increase the amount of paint. Turn it counter clockwise
to reduce it.
ADJUSTING THE SPRAY JET
You can adjust the spray jet from a round jet to a rather wide jet. For larger work pieces the latter
will be more convenient. This can be adjusted vertically as well as horizontally. To get a round
spray jet turn the spray jet regulator (#
3
) clockwise. Turn it counter clockwise to get a wide spray
jet.
NOTE
The professional operation of a spray gun takes some experience. Therefore we recommend
that you
experience the spray gun’s functions and its handling on a piece of paper or cardboard
before you start. Make a test run before each operation.
STORAGE
Contamination caused by dust or dirt can affect the gun’s efficiency. Wrap up the spray gun with
a piece of plastic or kitchen foil before you store it so that it is secured against any type
contamination and later damage.
