ENG
19
Operation Manual
MS-1040
•
Insert the plug of power cord
j
on the rear panel of subwoofer into the socket.
•
Adjust master volume level to its minimum by turning VOLUME control knob
d
counterclockwise
until it stops.
•
Shift POWER switch
a
on the subwoofer front panel, power LED
b
will illuminate on the
subwoofer front panel.
•
Switch on the audio source and adjust master volume level by turning VOLUME control knob
d
on the remote control. While turning the knob clockwise, volume level increases, but while turning it
counterclockwise, it reduces.
•
Adjust the subwoofer volume level by turning BASS control knob
h
. While turning the knob
clock- wise, the subwoofer volume level increases, but while turning it counterclockwise, it reduces.
Notes. If the speaker system has not been used for a long time, please mind to switch off
POWER
a
on the subwoofer rear panel and pull out its plug
j
from the socket.
9. TROUBLE SHOOTING
Problem
MSS does not
turn on.
No sound or there is
too quiet sound of
speakers.
Distortion of sound.
Sound is produced by
one of the channels
only.
Remote control is not
working.
Cause
MSS is not connected to the mains
outlet.
Power switch is o
ff
.
Volume level is set at minimum value.
Improperly connected audio source.
Large amplitude of the input signal.
Improperly connected speakers to
audio source.
Remote control is not connected to
the subwoofer.
Solution
Check the connection.
Turn on the switch.
Adjust volume control knob.
Connect audio sources correctly.
Turn down source volume
and MSS volume.
Check the connection of speakers.
Check the connection.
If none of the above mentioned solutions solves the problem, please refer to nearest authorized
service center for consultation by a quali
fi
ed specialist. Never try to repair the device on your
own.