Programming buttons without using software.
The switch buttons, shift lever, «11» and «12» buttons, as well as the gas and toroidal pedals, can be
assigned the following buttons: «1-8».
The programming algorithm is as follows:
1. Press the «PROG»
i
button, the green work indication LED
p
(green LED) will light up.
2. Press the programmable button, the green LED will ash.
3. Press the button whose value you want to assign, while the green LED goes out. The programmable
button is assigned a new value.
To return to the button the default values are:
1. Press the «PROG»
i
button, the green LED will light up.
2. Press the desired button, and the green LED will ash.
3. Press the desired button again, while the green LED goes out. The button is assigned the default
value.
To return all pre-programmed buttons, the default values are:
1. Press the «PROG»
i
button, the green LED will light up.
2. Press the «10» key for 3 seconds until the green LED goes out. All buttons will be assigned default
values.
Note: when the rudder is turned off from the PC, all settings will return to the default values.
To exit the programming menu (if no button was selected), simply press the «PROG»
!
i
!
button again.
Change of sensitivity of rotation of a rudder without use of ON.
The steering wheel has three levels of sensitivity: low, medium and high.
The algorithm for changing the sensitivity level is as follows:
1. Press the «9» and «10» keys simultaneously for 3 seconds, while the green indication LED
p
(green
LED).
2. Press the «9» button, the green LED ashing frequency will correspond to the set sensitivity level
(see Note).
3. Press the «9» button again to change the sensitivity level, and the green LED ash frequency will
correspond to the selected sensitivity level.
4. Press the «UP» button on the D-pad to save the setting.
Note: Each level of sensitivity corresponds to its own ashing frequency of the green LED: at a low
level, the LED ashes slowly, at medium - it is measured, at high level - quickly.
For use with PS3.
1. Connect the steering wheel to the PS3 console and connect the pedals to the handlebar.
2. Turn on the PS3 console.
3. The channel activation indicator will light when the connection is completed automatically.
ENG
Operation Manual
21
GC-W600
