Sven E-702BT, User Manual

Page: 3 / 16

ENG
3
E-702BT
User Manual
SAFETY PRECAUTIONS
• Don’t use the stereo headphones while driving.
• Don’t use the stereo headphones at high volume for a long time (more than 15 minutes),
as this may cause hearing impairment.
SPECIAL FEATURES
•
Bluetooth wireless signal transmission
•
Touch control of incoming calls and track switching
• Two additional sets of interchangeable ear pads
• Battery operation time up to 3 hours
• Operating time using a charging case up to 8-9 hours
CONNECTION
First connection
• Remove both headphones from the
charging case, then put them back to the case
to activate the headphones.
• If there is a protective film on the contacts,
you must remove it before using the
headphones.
•
The battery in the headphones and case
is used as an integral part of the device.
Before using for the first time, make sure
that the headphones are fully charged. If
the headphones are discharged, they need
to be fully charged (see headphone charging
section).
Fig. 1.
DESCRIPTION
a Multifunction sensor button
b Headphones LED indicator
c
Charging сase LED indicator
d Charging case
e TYPE-C jack for battery charging
Headset to a device interfacing
• It is necessary first to interconnect the device with a signal source (see the connection
diagram in Fig. 2) to transfer signals via Bluetooth. To pair the headphones with the device,
put them to the charging case, then get them out. Both earphones are automatically
switched on and connected to each other. At the same time on right earphone LED
indicator b will alternate blue and red glow.