Suzuki SWIFT RS415 2017, Service Manual

Page: 33 / 1257

Maintenance and Lubrication: 0B-4
NOTE:
When replacing belt with a new one, adjust
belt tension to 6 – 7 mm (0.24 – 0.28 in.).
3) Connect negative (–) cable to battery
Accessory Drive Belt Replacement
S4RS0A0206002
Water Pump and Generator Drive Belt
Replace belt with new one referring to “Water Pump /
Generator Drive Belt Removal and Installation: in
Section 1F”.
A/C Compressor Drive Belt (If Equipped)
Replace belt with new one referring to “Compressor
Drive Belt Removal and Installation: in Section 7B”.
Valve Lash (Clearance) Inspection
S4RS0A0206003
Inspect intake and exhaust valve lash and adjust as
necessary.
Refer to “Valve Lash (Clearance) Inspection: in Section
1D” for valve lash inspection and adjustment procedure.
Engine Oil and Filter Change
S4RS0A0206004
WARNING:
• New and used engine oil can be
hazardous.
Be sure to read “WARNING” in “General
Precautions: in Section 00” and observe
what is written there.
• Step 1) – 7) outlined below must be
performed with ENGINE NOT RUNNING.
For Step 8), be sure to have adequate
ventilation while engine is running.
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kg-m, 25.5
lb-ft)
3) Loosen oil filter by using oil filter wrench (special
tool).
Special tool
(A): 09915–47331
1. Camshaft 2. Thickness gauge
I4RS0A020001-
I2RH0B020003-
I2RH0B020004-
I2RH0B020005-