ENGINE 3-67
• Install the oil pump cover
4
.
STARTER CLUTCH AND GENERATOR ROTOR
• Apply engine oil to the starter driven gear bearing and crank-
shaft.
• Install the starter driven gear
1
.
• Degrease the tapered portion of generator rotor and also the
crankshaft. Use nonflammable cleaning solvent to wipe off
oily or greasy matter and make these surfaces completely
dry.
• Install the key
2
.
• Install the generator rotor
3
.
• Tighten the generator rotor nut to the specified torque with the
special tool.
"
Generator rotor nut: 80 N·m (8.0 kgf-m, 58 lb-ft)
\
09930-44520: Rotor holder
Summary of Contents for LT-Z90K7
