Suzuki Liana RH418, Supplementary Service Manual

Page: 349 / 371

Automatic Transmission/Transaxle: 5A-123
6) Rotate new spacer approximately 180 degrees.
7) Stake small hole of new spacer.
8) Press counter drive gear (1), using special tools.
Special tool
(A): 09924-74510
(B): 09926-68310
9) Install new snap ring (1) to angular ball bearing.
10) Apply A/T fluid to new O-rings.
11) Place 1st and reverse brake piston (1) with O-rings
installed.
NOTE
Be careful not to damage O-rings during
piston installation.
12) Mount 1st and reverse brake piston return spring (2).
13) Install retainer ring (1) by compressing brake piston
return spring with flat end rod or the like.
14) Install separator plates “S”, friction plates “F” and
retaining plates “R” in the following order.
R
→
F
→
S
→
F
→
S
→
F
→
S
→
F
→
S
→
F
→
R
15) Install snap ring (1).
NOTE
Make sure that opening end of snap ring
should be aligned with protrusion of
transaxle case.
I2RH01510234-01
I2RH01510235-01
I2RH01510236-01
I2RH01510237-01
I2RH01510238-01
I2RH01510121-01