Suzuki Intruder VZR1800, Service Manual

Page: 443 / 586

10-18 ELECTRICAL SYSTEM
• Tighten the starter motor mounting lead wire bolts
5
and nut
6
to the specified torque.
,
Starter motor mounting bolt: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
Starter motor lead wire nut: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
STARTER RELAY INSPECTION
• Remove the front seat. (
!
9-4)
• Remove the battery cover.
• Disconnect the battery
-
lead wire from the battery.
• Remove the starter relay cover
1
.
• Disconnect the starter relay coupler
2
, starter motor lead
wire
3
and battery lead wire
4
.
• Remove the starter relay.
• Apply 12 V to
A
and
B
terminals and check for continuity
between the positive and negative terminals using the
multi-circuit tester. If the starter relay clicks and continuity is
found, the relay is ok.
"
09900-25008: Multi-circuit tester set
-
Tester knob indication: Continuity test (
.
)
#
Measure the relay coil resistance between the terminals using
the multi-circuit tester. If the resistance is not within the specified
value, replace the starter relay with a new one.
"
09900-25008: Multi-circuit tester set
$
Starter relay resistance: 3 – 6
Ω
Do not apply battery voltage to the starter relay for
more than five seconds, since the relay coil may over-
heat and get damaged.