SUZUKI GENUINE ACCESSORIES
6
7. INSTALLATION
FOLLOW INSTRUCTIONS PAR. 12
7.1 Tow Bar/Rear Spare Tire
When a vehicle has a tow bar or a rear spare tire, the system can be configured to push out the impact detection zone past the
accessory. Configuration must be done by an authorized
SUZUKI dealer.
CONNECTION FOR VEHICLES WITH TOW BAR
Refer to installation-instructions of SUZUKI-Towbar-Wiring-Kit for detailed connection information.
8. PROGRAMMING
CAUTION
Only expert users should modify these settings to avoid malfunctions of the system.
System configuration is done by pressing buttons “
A
” and “
B
” (see figure below):
Press
button
“A”
to select the parameter to be configured.
Press
button
“B”
to select the desired setting.
8.1 How to enter in programming mode:
1. Turn ignition ON and engage reverse gear.
2. Simultaneously press buttons “
A
” and “
B
”.
3. Operation will be confirmed by 1 Beep and 1 Red/Green LED flash.
4. Wait until the LED turns OFF.
8.2 Parameter setup:
1. Within 10 sec. after the LED turns OFF, press button “
A
” the number of times corresponding to the parameter to
customize. 1 Beep and 1 Red LED blink will confirm each button press.
2. Press button “
B
” the number of times corresponding to the desired setup. 1 Beep and 1 Green LED blink will confirm
each button press.
Example:
To set maximum detection distance of inner sensors at 125 cm => press button “
A
” twice and then button “
B
” 7 times.
8.3 Setup confirmation:
1. The control unit will repeat the number of beeps and blinks corresponding to the selected setup. After a few seconds, if
the code has been successfully entered, the buzzer will give off a long beep (Beep, Beep, Beep).
2. If the entry is incorrect, the buzzer will emit a low tone signal (Bop) and the system will automatically exit the procedure.
3. After the confirmation beeps, other parameters can be configured by following the same procedure.
4. If no button is pressed within approx.10 sec., the system automatically exits programming mode.
8.4 How to restore factory settings:
1. Disconnect the connector from the unit.
2. Turn ignition key ON and engage reverse gear.
3. Simultaneously press and hold buttons “
A
” and “
B
” and reconnect the connector.
4. The LED will start blinking Red/Green.
5. When the buzzer gives off 1 Beep, release buttons “
A
” and “
B
”.
6. When the LED stops blinking, the system is reset to the original factory settings.
CAUTION
OBSTACLES BETWEEN THE BUMPER AND THE NEW STOP ZONE WILL NOT BE DETECTED.
Button
A
Button
B
LED