SUZUKI GENUINE ACCESSORIES
4
- IMPORTANT -
PRINT PAGES 4 & 5 BELOW FOR YOUR CUSTOMER
4. SYSTEM OPERATION
The system is automatically activated when ignition is turned ON and reverse gear is engaged
2 consecutive Beeps will
confirm activation. Detection of obstacles will be signalled by the buzzer.
The audible warning, with a series of beeps, will increase in pitch and frequency as the vehicle moves nearer a stationary
object: the faster the beeping the closer the obstacle.
The beeps become a continuous solid tone when the preset minimum safety distance (STOP zone) is reached.
WARNING
Presence of human beings, animals or small obstacles (lower than 35cm) or objects/materials with low
reflectance might not be detected by the parking system.
WARNING
a.
Remember to always look behind the vehicle while parking.
b.
If, once reverse gear is engaged and activation confirmed, the buzzer keeps beeping and no obstacle is
behind the vehicle, the parking system is defective: contact your Suzuki dealer.
c.
During any reverse manoeuvre, remember to always look behind for persons and obstacles. The
parking system is designed only as a parking aid, it should not be considered to replace care and
attentiveness while manoeuvring. Always check your wing mirrors and rear view mirror while reversing
and keep a slow speed to avoid unexpected hazards.
d.
In case of heavy rain or snow the parking system might give an audible alert even if no obstacles are
present: this does not necessarily indicate that the parking system is defective.
e.
In car washes which use steam jet or high-pressure washers, take care to keep the nozzle at least 10
cm away from the sensors.
5. TROUBLESHOOTING GUIDE
5.1 FAULTY SENSORS
When reverse gear is engaged, the parking sensor system provides an instant, automatic, self-diagnostic function. If all the
sensors are operative, 2 Beeps will confirm activation.
If one of the sensors is faulty or disconnected, a deep error tone (Bop) will sound followed by the number of beeps
corresponding to the faulty sensor. The cycle will repeat until all faulty sensors have been signalled. 2 Bops will confirm the end
the self-test cycle.
The system will exclude any faulty sensor and keep the other ones active. The following is an example of error indications:
Sensor 1 inoperative
=> 2 activation Beeps + 1 Bop +
1 Beep
+ 2 closing Bops.
Sensors 1 and 2 inoperative
=> 2 activation Beeps + 1 Bop +
1 Beep
+ 1 Bop +
2 Beeps
+ 2 closing Bops.