![background image](http://html1.mh-extra.com/html/suzohapp/bill-to-bill-xt/bill-to-bill-xt_operation-manual_1408244040.webp)
- 40 -
© 2015 Suzo-Happ
The denominations assigned these switches depend on the software in use. Please refer
to “Software Description for Bill to Bill Validator” document for details.
6.
Software Updates
Software updates can be performed using memory cards or from the host machine.
6.1.
Update from Memory Cards
Two types of memory cards are provided to perform updates. Single Load and Multi-
load. A single load card must remain in the validating head after update. A multi-load
card is used to perform updates on multiple units.
6.1.1.
Single Load Memory Card
Follow the process below.
1.
Turn power off.
2.
Remove the validating head.
3.
Remove the old memory card.
4.
Install the new memory card.
5.
Turn the DIP SW 2.4 to SERVICE mode.
6.
Install the validating head.
7.
Power on the validator.
8.
Wait while the indicator LED completes flashing green/red.
9.
Wait until the validator has finished initialisation.
10.
Observe the LED turn green.
11.
Power down the validator.
12.
Turn the Dip SW 4 to COMMUNICATION mode
13.
Power on the validator.
6.1.2.
Multi Load Memory Card
Follow the process below.
1.
Turn power off.
2.
Remove the validating head.
3.
Remove the old memory card.
4.
Install new memory card.
5.
Turn the DIP SW 2.4 to SERVICE mode.
6.
Install the validating head.
7.
Power on the validator.
8.
Wait while the indicator LED completes flashing green/red.