Periodic Maintenance
Technical Handbook
019722-101 Rev. 05
66
SC-350/360
10 Periodic Maintenance
WARNING!
Risk of electroshock!
Follow the Safety precautions!
Caution!
Do not attempt to oil or lubricate any parts in the machine. All
bearings are pre-lubricated and will be damaged if any lubricant is
added.
Note!
Some screws have nuts and/or washers. Be careful not to lose them
when removing the screws.
If not stated otherwise, re-assembly is the reverse of disassembly.
10.1 Exchanging the Feeding Belt
a) Set the diameter selector (1) to 34.0 mm
(max.).
b) Open the inspection cover.
c) Raise the feed mechanism (2).
d) Remove the old out-feed belt (3) and exchange it for a new one.
e) Replace the feed mechanism and the out-feed belt.
f) Close the inspection cover.
g) Reset the diameter selector to the desired position.
1 Diameter selector
2 Feed mechanism
3 Out-feed belt
3
2
1
