Suunto Spartan, User Manual

Page: 13 / 46

13
1.5.1. selecting the units of Measurement
to change the unit of measure displayed:
1. Check the mode indicator. If the mode arrow is not on tIme, PreSS the [mode] button until the arrow is
directly below tIme on the mode Indicator Bar.
2. PreSS the [mode] and [Select] buttons simultaneously and hold in for 3 seconds. field 1 will display “Set”
momentarily and then display “UnI” (fig. 30).
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.
WARNING: If the user presses the [Select] button (and does not hold for 2 seconds) while in the “UNI” setting
mode, the user will be in the Pressure Sensor Calibration. Refer to the next section for details.
3. PreSS the [Select] button and hold in for 2 seconds. located to the right in field 2, “m” or “ft” will begin
to flash.
4. PreSS the [+] button to toggle between “m” and “ft”.
5. at the unit of measure desired, PreSS the [Select] button to move to the next unit. located below the “m”
or ft” in Field 2, “mbar” or “inHg” will begin to flash.
6. PreSS the [+] button to toggle between “mbar” and “inHg”.
7. at the unit of measure desired, PreSS the [Select] button to move to the next unit. located at the top right
in Field 1 (just above the bubble), °C or °F will begin to flash.
8. PreSS the [+] button to toggle between °C and °f.
9. at the unit of measure desired, PreSS the [Select] button to move to the next unit. located at the top
center in Field 1, “m/min” or “ft/min” will begin to flash.
10. PreSS the [+] button to toggle between “m/min” and “ft/min”.
11. at the unit of measure desired, PreSS the [mode] button to accept the changes. PreSS the [mode] button
again to return to the main time mode.
Selecting the units of measurement is complete.