Sutter Instrument Lambda 421, Operation Manual

Page: 36 / 42

LAMBDA 421 OPERATION MANUAL – REV. 1.00N (20170623)
28
Value Command Tx/
-Rx
Ver
.
Byte
Count
Byte
Offset
Dec. Hex. Binary
Alt-
key-
pad
entry
Ctrl-
char
ASCII
def./-
char.
Description
loaded in the ring buffer. A maximum
of 100 filter values are allowed (all
entries in excess of 100 are ignored).
Ring
Buffer
Rx All
2 0
Echoed command sequence
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
1 0 240 F0 1111 0000 0240
Sent after the final filter value is
loaded in the ring buffer. This saves
the new ring buffer values and returns
to normal on-line mode.
End
Loading
Ring
Buffer
Rx All
2 0
Echoed command sequence
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
1 0 241 F1 1111 0001 0241
Begins filter position movement based
on what is defined in the ring buffer. A
trigger pulse steps from one definition
to the next, executing the movement
command.
Run from
Ring
Buffer
Rx All
2 0
Echoed command sequence
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
1 0 242 F2 1111 0010 0242
Returns to normal on-line mode
End Run
from Ring
Buffer
Rx All
2 0
Echoed command sequence
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
1 0 202 CA 1100 1010 0202
Selects triggered by strobe line as the
ring buffer mode
Rx All
2 0
Echoed command sequence
Enable
Ring
Buffer
Triggering
by Strobe
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
1 0 203 CB 1100 1011 0203
Deselects triggered by strobe line
Rx All
2 0
Echoed command sequence
Disable
Ring
Buffer
Triggering
by Strobe
1 13 0D 0000 1101 <CR>
Completion indicator
Tx All
2 0 246 F6 1111 0110 0246
Sets the immediate ring buffer trigger
by strobe mode (immediate (lost at
power down) & default (restored at
power up))
1 1 01 0000 0001 0001 ^A
Move on rising edge
Set Trigger
Pulse
Mode for
Ring
Buffer
2 02 0000 0010 0002 ^B
Move on rising edge, then to Filter 0
on signal falling
3 03 0000 0011 0003 ^C
Move on falling edge
4 04 0000 0100 0004 ^D
Move on falling edge, then to Filter 0
on signal rising