SiO Controller
SUS Corporation
3-9
3.3 Installation
3.3.1 Installation of Controller
Install the controller observing the following precautions.
◆
Avoid installation in direct sunlight.
◆
Prevent foreign matter from entering the controller.
◆
Avoid using in a place with high temperature, high humidity, dust, iron powder, cutting oil, or
the like.
3.3.2 Wiring to Controller
Wire the AC adapter and I/O cables as follows.
Be sure to turn OFF the power before wiring.
1. Wiring to controller and power connector
Connect 24 V DC to the power connector. It is recommended to use the dedicated AC adapter.
Otherwise, prepare a plug of the following size:
Do not supply power except from the power connector.
Because it does not pass through the protection circuit,Controller may fail.
5.5 mm (OD)
×
2.1 mm (ID),
Wiring symbol:
Plug
Jack
2. Connection of I/O cables
Connect I/O cables to the input/output connectors.
* Be sure to insert each connector until it clicks.
Before connection
After connection
Be sure to push down the lever before disconnecting the connector.
Forcibly pulling out the connector may result in a break in the wire.
!
CAUTION
!
CAUTION