Surveon CAM6181, User Manual, Page: 55 / 87

55
PTZ Function
Assign a camera function: Preset , Sequence , Autopan or Cruise , and specify a Preset
Point/Sequence Line/Autopan Path/Cruise Line for the camera to perform at an
alarm occurrence.
Note: Please refer to the sections through Preset to Sequence for details of
Preset Point/Cruise Line/Autopan Path/Sequence Line setups.
If the selected function is Preset , it is required to enter its dwell time (1~256 sec.) in
the corresponding field as shown below. When the alarm is triggered, the camera
will go to the selected Preset Point and stay there for a user-defined period of time.
As for other function modes, the camera will keep executing the specified function;
to stop the performance, simply change the camera’s status.
Note: The dwell time is only adjustable when selecting Preset as the alarm
action. When the dwell time is up, the Camera will go back to its trigger position
and recheck alarm pin status.
Send HTTP Notification
Check this item, select the destination HTTP address, and specify the parameters for
event notifications by Alarm triggered. When an alarm is triggered, the notification
can be sent to the specified HTTP server.
For instance, if the custom parameter is set as” action=1&group=2 ”, and the HTTP
server name is” http://192.168.0.1/admin.php ”, the notification will be sent to
HTTP server as” http://192.168.0.1/admin.php? action=1&group=2 ” when alarm is
triggered.
Record Stream to SD Card
Select the item and the alarm-triggered recording will be saved into your Micro SD
card.
Pre-trigger buffer recording function allows users to check what happened to cause
the trigger. The pre-trigger buffer time range is from 1 to 3 seconds.
Select Upload for __ sec to set the recording duration after alarm is triggered. The
setting range is from 1 to 99999 seconds.
Select Upload during the trigger active to record the triggered video until the
trigger is off.