13
E N G L I S H •
User's Manual
5. Turn release valve
counterclockwise to
the open position one
full turn and lower jack
to the lowest position.
6. Carefully and slowly
pinch oil fill plug to re-
lease trapped air.
7. Turn release valve
(R7) clockwise to the
closed position and
check for proper pump
action. It may be nec-
essary to perform the
above step more than
once to assume air is
evacuated totally.
8. Secure the handle in place inside the handle
socket. Without any weight on the jack. Cycle
the lift up and down several times to insure the
hydraulic system is operating properly. (Perform
to the Air Purge Procedure again if necessary.)
OPERATION INSTRUCTIONS
BEFORE USE
1. Before using this product, read the owner's
manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use.
2. Perform the air purge procedure. (See previ-
ous instructions for system purge procedure.)
3. Inspect before each use. Do not use if bent,
broken or cracked components are noted.
OPERATION
1. Insert the bed frame pins to desired height,
then lower the bed frame. Ensure bed frame is
fully rested on the bed frame pins.
2. Place bolster plates
(6) on press bed frame
as needed.
3. Place work piece on the bed frame or pressing
block, use every precaution necessary to ensure
safety and to prevent accidents. Position work
piece in a manner which will not allow it to in-
advertently fall from the bed frame or pressing
block.
4. With the notched (or
stamped) end of jack
handle (R22), close the
release valve by turn-
ing it clockwise until it
is closed firmly tight.
5. Insert jack handle into handle socket and
pump until jack nears work piece.
6. Keep jack and work piece aligned to ensure
center-loading.
NOTE: Stabilize work piece in a manner which
will not allow it to inadvertently fall from the
bed frame when the load is removed.
7. Apply load to work
piece by pumping han-
dle. Do not overload
work piece.
8. Stabilize work piece
in a manner which will
not allow it to inadver-
tently fall from the bed
frame when the load is
removed.
9. When work is com-
pleted, stop pumping
the handle. Slowly turn
the release valve coun-
ter-clockwise in small
increments until jack is
free from work piece.
10. Once jack has
fully retracted, remove
workplace from bed
frame. Cautiously re-
move work piece from
press.
