1. Remove the strap from the canopy.
2. Gently spread the canopy arms open
with your hands
(refer Figure A).
3. Ensure the turning knob for the slider
can move freely
(refer Figure B). Insert
the winder handle (30) into the hole on
the side of the mast and rotate in a
clockwise direction.
4. Continue winding until the canopy is
fully open and the edge of the canopy is
firm
(refer Figure C). Note: The winder
handle will become a little harder to wind
as the parasol is fully open. Stop winding
when the canopy is taut/firm. Do not
overwind.
5. Once the canopy is fully opened, hold
the turning knob (20) and push the slider
up until the canopy is at the desired tilt
angle. Tighten the knob (20) clockwise to
secure the parasol at that angle.
Important: The slider knob (20) must be
done up tightly, especially when used in
exposed locations. The parasol should
not be tilted when windy.
6. When the slider is pushed up to the
highest point, the locking pin (20) will
automatically engage, locking the canopy in
the horizontal position. The optimum strength
of the parasol is reached only when the
canopy is in the horizontal position, with the
slider at its maximum height and the locking pin
(20) engaged.
7. The tilt angle of the canopy can be adjusted as
required at any time by loosening the slider knob
(20), pulling the locking pin outward and sliding
the slider up and down the mast. Note: The
locking pin will only engage at the horizontal level.
Gently spread the canopy arms open
Figure A
Ensure tilt knob is loose (turn anti-clockwise)
when opening and closing parasol
Figure B
Edge of canopy should be tight
Figure C
TO OPEN PARASOL
Summary of Contents for SORRENTO Parasol
Page 1: ...Sorrento Parasol Instructions...
Page 13: ...SORRENTO PARASOL...