Sureshot Dispensing Systems AC2-GP, Operation Manual

Page: 10 / 28

AC2-GP Multi-Sweetener Dispenser
•
SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
6
Catch Tray and Screen
1. Remove the catch tray and screen by tilting
the front of the catch tray up towards the
dispenser and then pulling it away.
2. Rinse thoroughly with warm, clean water.
3. Wash in hot water with a good quality cleaner
at a water temperature between 140 °F/60 °C
and 170 °F/77 °C. Wash thoroughly to reach
all corners and crevices.
If a dishwasher is available, the items may be
cleaned on the full wash cycle.
4. Rinse well with warm, clean water.
5. Air dry
thoroughly .
6. Insert the screen into the catch tray.
7. Replace the catch tray and screen by tilting the front of the catch tray up towards the
dispenser and then pushing it under the front edge of the dispenser. Set down.
Top and Transition Piece (Fill-in-Place models only)
1. Remove the top by lifting it up and off the dispenser.
2. Remove the transition piece by lifting it up and off the dispenser.
3. Rinse the top and transition piece thoroughly with warm, clean water.
4. Wash in hot water with a good quality cleaner at a water temperature between 140
°F/60 °C and 170 °F/77 °C. Wash thoroughly to reach all corners and crevices.
If a dishwasher is available, the items may be cleaned on the full wash cycle.
5. Rinse well with warm, clean water.
6. Air dry
thoroughly .
7. Reinstall the top and transition piece on the dispenser.
Inside Compartment
1. Unplug the dispenser.
2. Wipe dispenser interior using a soft cloth dampened with warm, clean, soapy water.
3. Dry
thoroughly .
4. Plug in the dispenser.
Dispense Tube
Clean, sanitize and dry tubes thoroughly. Store spare tubes provided for future use.
1. Disable button panel.
a. Press and hold the

Panel Disable button on the button panel for 3 seconds
until beeps are heard. Lights on the button panel will flash in sequence.
2. Remove hopper. (Recommended to avoid spillage into dispenser.)
a. Open the dispenser door. Grasp door on the top right corner and swing out until
the door is opened fully (180°).
b. Remove tubes from guide plate.
c. Lift the hopper up slightly and pull it out of the dispenser.
3. Pull tubes from barbed fitting on the hopper.
4. Rinse thoroughly with warm, clean water.
5. Wash in hot water with a good quality cleaner at a water temperature between 140
°F/60 °C and 170 °F/77 °C.
If a dishwasher is available, the items may be cleaned on the full wash cycle. Ensure
tubes are upright to allow a thorough clean and drain.
6. Rinse well with warm, clean water.
7. Air dry
thoroughly .
8. Reinstall tubes by sliding tube onto barbed fitting on the hopper.
Steps 1 and 7. Catch Tray and Screen
Back edge