CM2000-WL 45dB
Dual Band Amplifier
User Manual
Model: CM2000-WL-45
FCC ID: RSNDUAL-62UNDER
IC: 7784A-D60UNDER
CONTENTS OF THE PACKAGE
fdgbsddg
1. CM2000-WL 45dB Amplfier
2. Right Angle Antenna
3. AC power supply
4. DC power supply
NOTE:
An outdoor antenna and 20-foot cable are required for
full operation. Please consult the Cellphone-Mate website
(
www.Cellphone-Mate.com
) or call toll-free at 888-365-MATE.
OPTIONAL: CM2000-WL-45 COMPLETE KIT:
fd
The complete KIT (CM2000-WL-45 KIT) includes outdoor and
indoor antenna as well as the cable required for full operation.
This is package is sold separately from the CM2000-WL-45.
1.CM2000-WL 45dB: 45dB Amplifier with power supplies
2. Right angle antenna
3. CM004-40-FN: 40ft CM400 Cable
4. CM288: Outdoor Antenna
SAFETY NOTES
fdgbsddg
The Federal Communications Commission (FCC) have tested this
product and found it to comply with their RF Exposure
Requirements, Pursuant to FCC Part 24. In order to comply with
the FCC RF exposure requirements,
the human user’s body
should always be separated from the indoor antenna of the
Amplifier by at least 25cm (10”).
Don't expose this product to extreme high or low temperature. For
example, putting the Amplifier under direct sunlight for too long may
cause it to overheat, thereby damaging the electronic components
inside.
There are no consumer serviceable or modifiable parts inside this
Amplifier product. Alteration or abuse of the Amplifier or other
components will void this product’s warranty, and could be
dangerous to the user.
CONNECTING THE AMPLIFIER INDOORS
gbsddg
The signal is received by the outside antenna from the cell tower,
then AMPLIFIED and transmitted to your phone through the inside
antenna. When the phone transmits, the signal is received by the
inside antenna, then AMPLIFIED and transmitted to the cell tower
through the outside antenna.
Connect the Inside Antenna:
The patch antenna is intended for
indoor use only. The inside antenna should be mounted within 200
square feet from where the phone is used.
Do not mount on a
surface within 4 inches of metal. Remove the cap from the
Amplifier connector labeled
CELLPHONE
. Screw the patch
antenna in to the
CELLPHONE
connector and make sure to tighten
it.
NOTE:
The internal antenna always needs to be positioned
vertically. The inside antenna must be mounted with a separation
distance of at least 10 inch (25 cm) from all people and must not be
co-located in conjunction with any other antenna or amplifier.
WARNING: The SMA connector is fragile when used with thick
cable such as 9311. Handle it with extra caution, otherwise
the connector could break, and it might not be covered under
the manufacturer’s warranty.
Connect the Outside Antenna:
The outdoor antenna is for
outdoor use only. Select an outside mounting location. For best
performance, keep the antenna on top of the roof. The outside
antenna should be located in an area with at least a 12” radius clear
of obstructions, and other radiating elements. Remove the cap from
the Amplifier connector labeled
ANTENNA
. Screw the outside
antenna in to the
ANTENNA
connector and tighten it.
NOTE:
Keep the separation distance between the inside and
outside antennas at least 20ft apart.
WARNING: The outside antenna must be mounted with a
separation distance of at least 20’’ from any of the vehicle