1. Inspect the clipper, making sure that it is free of oil between the cutting blade teeth and
turn the unit on to distribute the oil and to make sure it is running smoothly. Wipe off any
excess oil. This should be done after each use. While using the unit, untwist the cord from
time to time to avoid tangling.
2. Seat the person so their head is approximately at your eye level. This allows ease of
visibility while cutting and a relaxed control of the unit.
3. Before cutting always comb the hair first so that it is tangle-free and as it is naturally
worn.
1. Guide combs should be installed by first hooking the blade teeth front side of the guide
comb. Then press the back of the guide comb down until it snaps into place.
2.Ensure the comb is attached before beginning to cut hair.
3. To remove, pull the snap tab on backside of the guide comb and pull the comb off.
● Using the comb attachment 9mm or 12mrn, cut the top of head from back to front against
the direction in which the hair normally grows (see diagram 4). In some cases, this may
require the reverse, or cutting from front to back.
● Comb attachments 3mm or 6mm are used to achieve a close crew cut or short cut.
● For longer hair on top, use the comb provided and lifts the hair on the top of the head. Cut
