Installation
Wiegand and other cable connections
Restoring the Factory Defaults
This will reset all settings stored on the device.
1.
Turn the power on.
2.
Press the reset button three times quickly.
3.
When the green LED is blinking, press the reset button again.
Resetting the baud rate of RS-485
1.
Turn the power on.
2.
Press and hold the reset button for more than 2 seconds. When the device change to setup mode, the green LED is blinking.
3.
Depending on the number of times the reset button was pressed, the baud rate changes. You can recognize the baud rate
according to the LED color.
The number of times
Baud Rate
LED Color
1
9600
Cyan
2
19200
Blue
3
38400
Magenta
4
57600
White
5
115200
Red
4.
The LED blinks for 5 seconds with the color set as the above. The baud rate is set once you hear a beep sound.
NOTE
•
If you do not press the reset button after changing to the setup mode, the baud rate is set to 115200.
1 - PWR +VDC
Red
2 - GND
Black (White stripe)
5 - WG D0
Green
6 - WG D1
White
7 - LED RED
Orange
8 - LED GRN
Brown
9 - BEEP
Purple
10 - TMPR
Gray
Control device
XPass D2
DC power
