2: Back Axle & Tire Assembly:
Disconnect & remove the rear motors from the vehicle. Slide rear
axle into place. Slide the rear motors onto axle with the motor and
connected wires are toward the inside of the car. Need to slide the
motor and wires through the round opening in the motor support
bracket mounted on the axle. It is also important to ensure the
placement of each motor to be on the correct, right/left side of the
car.
NOTE: If the motors happen to get mounted on the incorrect
side during the assembly process it will make the vehicle drive in
the wrong direction.
Reattach motor connections in the battery
area. Next you will need to slide the tire on the axle followed by a
washer, and lock nut. Tighten lock nuts with a 17mm socket until
the end of the axle is even with the outside of the lock nut. (Do not
over tighten) Snap wheel cover into place by lining up the tabs on
the wheel cover with the corresponding slots in the wheels.
