Supero X10SAT, User Manual

Page: 86 / 117

4-16
X10SAT User’s Manual
Memory Frequency Limiter
This feature limits the frequency on which the system memory operates. The
settings are
Auto , 1067, 1333, and 1600d.
Max TOLUD (Top of Low Usable DRAM)
This feature sets the maximum TOLUD value, which specifies the "Top of Low
Usable DRAM" memory space to be used by internal graphics devices, GTT
Stolen Memory, and TSEG, respectively, if these devices are enabled. The op
-
tions are Dynamic , 1 GB, 1.25 GB, 1.5 GB, 1.75 GB, 2 GB, 2.25 GB, 2.5 GB,
2.75 GB, 3 GB and 3.25 GB.
Note: TSEG is a block of memory that is only accessible by the processor
while operating in System Management Mode (SMM).
Memory Scrambler
This feature enables or disables memory scrambler support for memory error
correction. The settings are
Enabled and Disabled.

PCH-IO Configuration
This item displays the information for the PCH-IO Chip.
•
Intel PCH Rev ID
•
USB Configuration
•
USB Devices: 1 Keyboard, 1 Mouse, 2 Hubs
EHCI1
Select Enabled to enable EHCI (Enhanced Host Controller Interface) Controller 1
for USB 2.0 support. One EHCI controller must always be enabled. The settings
are
Enabled and Disabled.
EHCI2
Select Enabled to enable EHCI (Enhanced Host Controller Interface) Controller 2
for USB 2.0 support. One EHCI controller must always be enabled. The settings
are
Enabled and Disabled.
Legacy USB Support
Select Enabled to support legacy USB devices. Select Auto to disable legacy
support when legacy USB devices are not present. If Disable is selected, legacy
USB devices will not be supported. The options are
Enabled, Disabled and Auto.