Supero SuperWorkstation 5038AD-T, User Manual

Page: 78 / 130

6-10
S
uper
W
orkstation 5038AD-T User's Manual
Figure 6-9. Expansion Card Components
6-5 Installing Expansion Cards
PCI Slot Setup
The SC732G chassis has room to support up to seven full-height, full-length PCI
expansion cards. The number of cards used varies, depending upon the mother-
board models.
Installing Expansion Cards
1. Power down the system, disconnect the power cord from the rear of the
power supply and remove the chassis cover as described in Section 6-2.
Place the chassis on a fl at, stable surface.
2. Depress the release latch (A), which holds the protective bracket (B) and
secures the expansion card brackets to the chassis.
3. Lower the protective bracket from over the top of the expansion card dummy
brackets as shown in the lower illustration.
4. Remove the PCI slot covers from the PCI slots.
5. Simultaneously slide the expansion card into the motherboard and the PCI
slot bracket into the PCI slot on the chassis.
6. If desired, screws can be used to secure the expansion card into the chassis.
7. Close the protective bracket over the tops of the expansion card brackets.
Release
Latch (A)
Protective Bracket
(B)
PCI Slots
1
4
1
3
1
2