Supero SuperServer E200-8B, User Manual

Page: 12 / 92

1-4
S
UPER
S
ERVER E200-8B User's Manual
1-4 Server Installation and Setup
The server is shipped with the processor installed, and the motherboard installed in
the chassis. Several steps are necessary to begin using your server. You must add
memory, mount the hard disk drive, and mount the system in place.
Unpacking the System
Inspect the box in which the system was shipped and note if it was damaged. If the
server itself shows damage, file a damage claim with the carrier.
Warnings and Precautions
•
This product is not suitable for use with visual display work place devices
acccording to §2 of the the German Ordinance for Work with Visual Display Units.
•
Review the electrical and general safety precautions in Chapter 4.
•
Use a regulating uninterruptible power supply (UPS) to protect the server from
power surges, voltage spikes and to keep your system operating in case of a
power failure.
Adding Components to your System
•
Memory : If your system is not already fully integrated with system memory,
refer to Chapter 2 for details on compatible types of memory and the installation
procedure.
•
Drives and Storage : To add storage capabilities to your server, see Chapter 3.
•
Input/Output: See Chapter 2 for I/O ports and connect them as needed.
•
Software
: See Chapter 2 for description and procedures for installing software,
including drivers and monitoring programs.
•
Mounting
: To use the mounting brackets, see the procedure in Chapter 3.