Supero SuperServer 7043L-8R, User Manual

Page: 65 / 114

Chapter 6: Advanced Chassis Setup
6-3
6-2 Front Control Panel
The front control panel must be connected to the JF1 connector on the
motherboard to provide you with system status and alarm indications. A
ribbon cable has bundled these wires together to simplify this connection.
Connect the cable from JF1 on the motherboard (making sure the red wire
plugs into pin 1) to the appropriate connector on the front control panel PCB
(printed circuit board). Pull all excess cabling over to the control panel side
of the chassis. The control panel LEDs inform you of system status - see
Figure 6-2 for details. See Chapter 5 for details on JF1.
Figure 6-2. Front Control Panel LEDs
Power
NIC1
HDD
Power Fail
Overheat
Indicates power is being supplied to the system.
Indicates network activity on GLAN Port 1.
Indicates IDE hard disk/CD-ROM drive activity.
Indicates a power supply failure.
Indicates an overheat condition in either one of the
processors.
NIC2
Indicates network activity on GLAN Port 2.
1
2