Supero SuperServer 6025B-8, User Manual

Page: 42 / 122

5-8
S
UPER
S
ERVER 6025B-T/6025B-8 User's Manual
Figure 5-3. Installing DIMM into Slot
To Install: Insert module
vertically and press down
until it snaps into place.
Pay attention to the bot-
tom notch.
To Remove: Use your
thumbs to gently push
each release tab outward
to free the DIMM from
the slot.
Memory Support
The X7DBE/X7DB8 supports up to 32 GB of ECC FBD (Fully Buffered DIMM)
DDR2-667 or DDR2-533 SDRAM. The memory is an interleaved confi guration,
which requires modules of the same size and speed to be installed in pairs. You
should not mix DIMMs of different sizes and speeds. See Figure 5-3 for installing
memory modules.
Note: Notches
should align
with their
receptive points
on the slot
Notch
Notch
Release
Tab
Release
Tab
Memory Installation Table
Branch0 Branch1
Number of
DIMMs
Bank 1
(Channel 0)
Bank 2
(Channel 1)
Bank 3
(Channel 2)
Bank 4
(Channel 3)
2 DIMMs 1A ------ 2A ------ ------ ------ ------ ------
4 DIMMs 1A ------ 2A ------ 3A ------ 4A ------
6 DIMMs 1A 1B 2A 2B 3A ------ 4A ------
8 DIMMs 1A 1B 2A 2B 3A 3B 4A 4B
Notes: 1. DIMM slot# specified = populated DIMM slot; “---“ = unpopulated DIMM
slot. 2. Both FBD 533 MHz and 667MHz DIMMs are supported, however, you need to
use memory modules of the same speed and type. 3. Interleaved memory is
supported when pairs of DIMM modules are installed. To optimize memory
performance, please install pairs of DIMMs in
both Branch 0 and Branch 1 . 4. For
memory to work properly, you need to follow the restrictions listed above. )