Supero SUPERSERVER 6015B-Ni, User Manual

Page: 25 / 120

Chapter 2: Server Installation
2-9
Figure 2-5. Accessing the Inside of the SuperServer 6015B-Ni
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the hard drives have been properly installed
and all connections have been made.
1. Accessing the drive bays
For servicing the hard drives, you will need to remove the top chassis cover. If
you need to remove or install hard drives, please refer to Chapter 6.
2. Check the airfl ow
Airfl ow is provided by two heavy-duty 10-cm blower fans. The system com-
ponent layout was carefully designed to direct suffi cient cooling airfl ow to the
components that generate the most heat. Note that all power and data cables
have been routed in such a way that they do not block the airfl ow generated
by the fans.
3 . Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that offers
protection from electrical noise and power surges. It is recommended that you
use an uninterruptible power supply (UPS). Turn on the power switch on the
back of the power supply, then depress the power button on the front chassis
control panel.