Supero SuperServer 5017GR-TF, User Manual

Page: 36 / 100

5-4
S
UPER
S
ERVER 5017GR-TF User's Manual
5-4 Installing the Processor and Heatsink
!
Avoid placing direct pressure to the top of the processor package. Always
remove the power cord fi rst before adding, removing or changing any
hardware components.
Notes:
•
Always connect the power cord last and always remove it before adding, re-
moving or changing any hardware components. Make sure that you install the
processor into the CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an Intel-certifi ed multi-
directional heatsink only.
•
Make sure to install the motherboard into the chassis before you install the
CPU heatsinks.
•
When receiving a motherboard without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent;
otherwise, contact your retailer immediately.
•
Refer to the Supermicro web site for updates on CPU support.
Installing an LGA 2011 Processor
Follow the procedure below to install a
CPU.
1. There are two levers on the LGA
2011 socket. First press and release
the load lever labeled 'Open 1st'.
2. Press the second load lever labeled
'Close 1st' to release the load plate
from its locked position.
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
Press down on the lever labeled
'Close 1st'
Pull lever away
from the socket