Supero SUPERSERVER 5017C-MTF, User Manual

Page: 52 / 94

5-20
S
UPER
S
ERVER 5017C-MTF/5017C-MTRF User's Manual
LAN Port Enable/Disable
Use JPL1/JPL2 to enable or disable LAN
Ports 1 and 2 on the motherboard. See
the table on the right for jumper settings.
The default setting is enabled.
LAN Port En/Disable
Jumper Settings
Pin# Defi nition
1-2 Enabled
2-3 Disabled
USB Wake-Up
Use the JPUSB1 jumper to wake your
system by pressing a key on a USB
keyboard or clicking USB mouse. This
jumper is used together with the USB
Wake-Up feature in the BIOS. Enable this
jumper and the USB feature in the BIOS
to wake-up your system via USB devices.
The default setting is enabled.
USB Wake-up
Jumper Settings
Pin# Defi nition
1-2 Enabled (Default)
2-3 Disabled
BMC Enable/Disable
JPB is used to enable or disable the BMC
(Baseboard Management Control) chip
and the onboard IPMI connection. This
jumper is used together with the IPMI set-
tings in the BIOS. The default position is
on pins 1 and 2 to Enable BMC. See the
table on the right for jumper settings.
BMC IPMI Enable/Disable
Jumper Settings
Settings Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
PCI Slot SMB Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Closed Enabled
Open (Default) Disabled
PCI Slot SMB Enable
Use Jumpers JI
2
C1/JI
2
C2 to enable PCI
SMB (System Management Bus) support
to improve system management for the
PCI slots. Default is disabled. See the
table on the right for jumper settings.
Watch Dog Enable
Watch Dog is a system monitor that can
reboot the system when a software ap-
plication hangs. Close pins 1-2 to reset
the system if an application hangs. Close
pins 2-3 to generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled