Chapter 5: Advanced Motherboard Setup
5-11
Power LED/Speaker (JD1)
On the JD1 header, pins 1~3 are used for
a power LED and pins 4~7 are used for
an external speaker. If you wish to use
the onboard speaker, you should close
pins 6-7 with a jumper. See the table on
the right for speaker pin de
fi
nitions.
Speaker Connector
Pin Defi nitions
Pin Setting De
fi
nition
Pins 6-7
Internal Speaker
Pins 4-7
External Speaker
Internal Speaker/Buzzer (SP1)
The Internal Speaker on SP1 can be
used to provide audible indications for
various beep codes. See the table on
the right for pin de
fi
nitions. Refer to the
layout below for the locations of the In-
ternal Buzzer (SP1).
Internal Buzzer
Pin Defi nition
Pin# De
fi
nitions
Pin 1
Pos. (+)
Beep In
Pin 2
Neg. (-)
Alarm
Speaker
Universal Serial Bus (USB 0/1)
There are two Universal Serial Bus (USB
3.0) ports located on the I/O backpanel.
These support data transfer speeds of up
to 5Gb/sec. See the tables on the right for
pin de
fi
nitions.
Back Panel USB
Type A USB
Pin Defi nitions
Pin# De
fi
nition
1
+5V
2
USB_PN
3
USB_PP
4
Ground
TPM Header (JTPM1)
The TPM header is used to connect a
Trusted Platform Module (TPM), avail-
able from a third-party vendor. A TPM is
a security device that allows encryption
and authentication of hard drives. It en-
ables the motherboard to deny access if
the TPM associated with the hard drive is
not installed in the system. See the table
on the right for pin de
fi
nitions.
Trusted Platform Module Header
Pin Defi nitions
Pin # De
fi
nition
Pin # De
fi
nition
1
LCLK
2
GND
3
LFRAME
4
No Pin
5
LRESET
6
VCC5
7
LAD3
8
LAD2
9
VCC3
10
LAD1
11
LAD0
12
GND
13
RSV0
14
RSV1
15
SB3V
16
SERIRQ
17
GND
18
CLKRUN
19
LPCPD
20
RSV2
Summary of Contents for SUPERSERVER 5017A-EF
