Supero Supero SUPERSERVER 5015A-EHF-D525, User Manual

Page: 22 / 90

2-6
S
UPER
S
ERVER 5015A-EHF-D525 User's Manual
2-5 Checking the Motherboard Setup
After you install the 5015A-EHF-D525 in the rack, you will need to open the unit
to make sure the motherboard is properly installed and all the connections have
been made.
Accessing the Inside of the System (Figure 2-3)
First, grasp the two handles on either side and pull the unit straight out until it 1.
locks (you will hear a "click").
Remove the fi ve screws that hold the chassis cover in place.There are two 2.
screws on each side of the chassis, and one screw on the back.
Once the screws have been removed, lift the cover upward to remove it from 3.
the chassis.
Checking the Components
Your 5 4. 015A-EHF-D525 server system may have come with system memory
already installed. Make sure all DIMMs are fully seated in their slots. For
details on adding system memory, refer to Chapter 5.
If desired, you can install an add-on card to the system. See Chapter 5 for 5.
details on installing an add-on card.
Make sure all power and data cables are properly connected and not blocking 6.
the airfl ow. See Chapter 5 for details on cable connections.
Warning: Except for short periods of time, do NOT operate the server
without the cover in place. The chassis cover must be in place to allow
proper airfl ow and prevent overheating.
!