Supero SUPER P5MMA2, User Manual

Page: 52 / 64

2-20
SUPER P5MMA98/P5MMS98/P5MMA2/P5MMS2 User’s Manual
To Remove:
Use your thumb to gently push the edge of
the socket and release the module. Do this
on both sides for each module.
To Install:
Insert at an
angle, then
snap upright
into place.
Figure 2-1. Installing/Removing a SIMM/DIMM Memory Module
SIMM/DIMM
2-5 Installing/Removing the SIMM Modules
SUPER P5MMA98/P5MMS98/P5MMA2/P5MMS2 can accommodate a
maximum of 256 MB of on-board memory, using standard 72-pin
SIMM or 168-pin unbuffered DIMM memory modules. You can use
any 1 MB, 2 MB, 4 MB, 8 MB, 16 MB, or 32 MB 32/36 bit EDO (Ex-
tended Data Output), Fast Page Mode, or SDRAM modules. Do not
populate U6, J33 and J34 at the same time since they share the
same RAS signal. U6 is Bank 1 for the SDRAM (synchronous
DRAM). J33 and J34 are Bank 1 for the FPM/EDO DRAM. You
can put any 3.3V SDRAM/EDO/FPM on U5 and U6.
Refer to Figure 2-1 and the instructions below for installing or re-
moving SIMM/DIMM modules.