2-12
SC513 Chassis User’s Guide
H-2. Installing the Blower and the Air Shroud for a UP System
After the motherboard and the heatsink(s) have been installed in the chassis,
you need to install cooling fans and an air shroud for proper system cooling.
Procedures
(*Installing the Blower for a UP System)
1. Locate two mounting holes on the rubber pad and their corresponding tabs
on the chassis as shown in the picture below.
2. Place the rubber pad in the chassis and make sure that the rubber pad is
properly seated on the bottom of the chassis.
3. Place the blower on top of the rubber pad and make sure that the blower is
securely installed in the chassis.
Procedures (*Installing the Air Shroud)
After the blower has been properly installed in the chassis, you will need to
install the air shroud for proper cooling .
4. Locate the two openings on the air shroud and the two screws on the
heatsink as shown in the picture.
5. Place the air shroud on top of the heatsink by sliding the two openings of
the air shroud into the two screws on the heatsink. Make sure that the air
shroud is properly installed in the chassis as shown in the picture.
1
1a
1b
3
4a
4b