Supero H8DG6, User Manual

Page: 39 / 76

Chapter 2: Installation
2-17
I2C to PCI-Express Slot
JI
2
C1/JI
2
C2 allows you to enable the I
2
C bus
to communicate with the PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.
I 2 C to PCI-Express Slot
Jumper Settings
(JI
2
C1/JI
2
C2)
Jumper Setting Defi nition
Closed Enabled
Open Disabled
BMC Jumper
JPB1 is used to enable or disable theBMC
(Baseboard Management Control) Chip and
the onboard IPMI connection.This jumper is
used together with the IPMI settings in the
BIOS. The default position is on pins 1 and
2 to Enable BMC. See the table on the right
for jumper settings.
BMC Jumper Enable (JPB1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
LAN Enable/Disable
Change the setting of jumper JPL1 to enable
or disable the LAN1/2 Ethernet ports. See
the table on the right for jumper settings. The
default setting is enabled.
LAN Jumper Settings
(JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SAS Enable/Disable
JPS1 allows you to enable or disable the
SAS controller. The default position is on
pins 1 and 2 to enable SAS. See the table
on the right for jumper settings.