Supero H8DG6, User Manual

Page: 36 / 76

H8DG6/i(-F) Serverboard User's Manual
2-14
SGPIO
The T-SGPIO1/ T-SGPIO2 (Serial General
Purpose Input/Output) headers provide a bus
between the SATA controller and the backpane
to provide SATA enclosure management
functions. Connect the appropriate cable
from the backplane to the T-SGPIO1 header
to utilize SATA management functions on
your system.
SGPIO Header Pin Defi nitions
(T-SGPIO1/TSGPIO2)
Pin# Defi nition Pin # Defi nition
1 NC 2 NC
3 Ground 4 Data
5 Load 6 Ground
7 NC 8 NC
Note: NC indicates no connection.
Universal Serial Bus Ports
Two Universal Serial Bus ports (USB 2.0)
are located beside the Keyboard and Mouse
PS2 ports (USB0/1). Two additional Type
A ports (USB6/7) are also included on the
motherboard. See the table on the right for
pin defi nitions.
Universal Serial Bus Ports
Pin Defi nitions (USB 0/1,
USB6/7)
USB0
Pin # Defi nition USB1
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
USB Headers
Four USB 2.0 headers (USB2/3 and USB4/5)
are also included on the motherboard. These
may be connected to provide front side
access. A USB cable (not included) is needed
for the connection. See the table on the right
for pin defi nitions.
Universal Serial Bus Headers
Pin Defi nitions (USB2/3,
USB4/5)
USB2
Pin # Defi nition USB3
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 Key 5 NC
Note: NC indicates no connection.
UID Button
Pin Defi nitions
Pin# Defi nition
1 Ground
2 Ground
3 Button In
4 Ground
Unit Identifi er Button
There is a Unit Identifi er (UID) button on the
rear I/O of the board. There is also another
UID button located on the control panel.
When you push either UID button, both
Rear UID and Front Panel UID Indicators will
illuminate. Push either button again to turn off
both indicators. These UID indicators provide
easy identifi cation of a system unit that may
be in need of service.