Supero FatTwin F517H6-FT, User Manual, Page: 69 / 130

Chapter 5: Advanced Motherboard Setup
5-17
Chassis Intrusion (JL1)
A Chassis Intrusion header is located
at JL1 on the motherboard. Attach the
appropriate cable from the chassis to
inform you of a chassis intrusion when
the chassis is opened.
Chassis Intrusion (Jl1)
Pin Defi nitions
Pin# Defi nition
1 Intrusion Input
2 Ground
Power Supply I2C (JPI2C1)
The Power Supply I2C Connector,
located at JPI2C, monitors the status
of the power supply, fan and system
temperature. See the table on the right
for pin defi nitions.
PWR SMB (JPI 2 C1)
Pin Defi nitions
Pin# Defi nition
1 Clock
2 Data
3 PWR Fail
4 Ground
5 NC
TPM Header (JTPM1)
This header is used to connect a Trusted
Platform Module (TPM), that is available
from a third-party vendor. A TPM is a
security device that allows encryption
and authentication of hard drives. It
enables the motherboard to deny access
if the TPM associated with the hard drive
is not installed in the system. See the
table on the right for pin defi nitions.
Trusted Platform Module Header
(JTPM1) Pin Defi nitions
Pin# Defi nition Pin# Defi nition
1 LCLK 2 GND
3 LFRAME 4 No Pin
5 LRESET 6 VCC5
7 LAD3 8 LAD2
9 VCC3 10 LAD1
11 LAD0 12 GND
13 RSV0 14 RSV1
15 SB3V 16 SERIRQ
17 GND 18 CLKRUN
19 LPCPD 20 RSV2
SATA DOM Power Connector
The SATA DOM Power on JSD1 is used
to supply power to SATA Disk-on-Module
(DOM) solid-state storage devices.
Connect an appropriate cable here to
provide power support for your SATA
DOM devices.
DOM PWR (JSD1)
Pin Defi nitions
Pin# Defi nition
1 +5V
2 Ground
3 Ground