Supero C2SEA, User Manual

Page: 68 / 91

4-8
C2SEA/C2SEE User’s Manual
function to reallocate the overlapped physical memory to a location above the
total physical memory to resolve the memory overlapping situation. The options
are Enabled and Disabled.
PCI MMIO Allocation
Use this feature to assign the address for PCI Memory-mapped IO (MMIO)
allocation. The Default setting is 4 GB to 3200 MB .
DRAM Frequency
This feature allows the user to select the DRAM Frequency setting. The options
are Auto (Auto-detect) , 533 MHz, 667 MHz, 800 MHz, 1067 MHz and 1333
MHz
Confi gure DRAM Timing by SPD
Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip
which is built in the memory module in order to get the exact memory specifi ca-
tions. The options are Enabled and Disabled.
Memory Hole
Use the feature to allocate memory resource reserved for use of PCI devices. If
set to 15 MB~16MB, the reserved memory will be placed in the location around
15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB.
Initiate Graphics Adapter
Use this feature to select the graphics controller to be used as the primary boot
device. The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI . See
below for an explanation of the acronyms. For example, if PEG/PCI is selected,
the system will look for a PCI-E graphics (PEG) adapter fi rst, if none is found
then it uses the PCI graphics (PCI) adapter to boot with.
PEG - P CI- E G raphics adapter (optional add-on card)
PCI - PCI graphics adapter (optional add-on card)
IGD - I nternal G raphics D isplay (built-in)
IGD Graphics Mode Select
Use the feature to set the amount of system memory to be used by the Internal
Graphics Devices. The options are Disabled, Enabled 32 MB , Enabled 64 MB,
and Enabled 128 MB.
IGD GTT Graphics Memory Size
This feature allows the user to select the IGD GTT Graphics Size. The Default
setting is No VT Mode, 2 MB .