Supero AS2021M-UR Plus, User Manual

Page: 43 / 104

Chapter 5: Advanced Serverboard Setup
5-9
Top View of DDR2 FBD Slot
Figure 5-3. Installing DIMM into Slot
To Install: Insert module vertically
and press down until it snaps into
place. Pay attention to the bottom
notch.
To Remove: Use your thumbs
to gently push each release tab
outward to free the DIMM from the
slot.
DDR2 FBD DIMM
5-6 Adding PCI Expansion Cards
1. PCI Expansion Slots
The SC825TQ-R700U chassis can accommodate the full complement of add-on
cards available to the H8DMU+.
Add-on cards are installed into riser card that has been pre-installed to the system.
See confi guration list below.
2. Card installation
Before installing a PCI add-on card, make sure you install it into the correct slot
on the riser card. Begin by releasing the locking tab that corresponds to the slot
you wish to populate. Insert the expansion card into the correct riser card, pushing
down with your thumbs evenly on both sides of the card.
Left Side Riser Card Expansion cards supported
CSE-R2UU-UA3E8 1x UIO card
3x PCI-Express x8 cards
Right Side Riser Card Expansion cards supported
CSE-R2UU-2E8R 1x low-profi le PCI-E x8 card
1x low-profi le PCI-E x4 card (in x8 slot)