Chapter 4: BIOS
87
Onboard LAN1 Option ROM
Use this feature to select which firmware function to be loaded for LAN Port1 used for system
boot. The options are Disabled and
EFI
.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Disabled and
Enabled
.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and
Enabled
.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are
Disabled
and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and
Enabled
.
IPv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are
Disabled
and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is
0
.
Media Detect Count
Use this option to specify the number of times media will be checked. Press "+" or "-" on your
keyboard to change the value. The default setting is
1
.
SATA And RST Configuration
SATA Controller(s)
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are
Enabled
and Disabled.
SATA Mode Selection
Use this feature to select the SATA mode. The options are
AHCI
and Intel RST Premium
With Intel Optane System Acceleration.
*If the feature above is set to Intel RST Premium With Intel Optane System Acceleration,
the next four features will be available for configuration:
SATA Interrupt Selection
Use this feature to select the SATA interrupt. The options are
Msix
, Msi, and Legacy.