Chapter 4: UEFI BIOS
93
SATA HDD Unlock (Available when SATA Controller is set to Enable)
Select Enable to unlock SATA HDD password in the OS. The options are
Enable
and Disable.
SATA/sSATA RAID Boot Select (Available when Configure SATA as is set to RAID)
This feature allows the user to decide which controller should be used to boot the system.
The options are None, SATA Controller,
sSATA Controller
, and Both.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Enable and
Disable
.
SATA RAID Option ROM/UEFI Driver (Available when Configure SATA as is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and
Legacy
.
SATA Port 0 - SATA Port 3
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are
Enable
and Disable.
Spin Up Device
When this feature is set to Enable, the SATA device installed on the SATA port specified by
the user will start a COMRESET initialization when an edge is detected from 0 to 1. The
options are Enable and
Disable
.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are
Hard
Disk Drive
and Solid State Drive.
