28
X10SDE-DF User Manual
BMC
SW2
CPU2
CPU1
X10SDE-D
F
Re
v. 1.00
J27
P1-JBT1
P1-JPME1
P1-JPME2
P2-JPME2
P2-JPME1
P1-BT1
P2-BT1
P2-JBT1
P2-DIMMA
1
P2-DIMMA
2
P2-DIMMB
1
P2-DIMMB
2
P1-DIMMB
2
P1-DIMMB
1
P1-DIMMA
2
P1-DIMMA
1
BAR
CO
DE
MAC
CO
DE
MAC
CO
DE
P1-JPL1
LEDM2
LEDM1
P2-JPG1
P1-JPG1
P2-JWD1
P1-JWD1
KVM
SW1
P2 Power LE
D
P1 Power LE
D
IPMI_LAN
P1-JPB1
P2-JPL1
LED7
P2-JPB1
P1 LAN1
P2 LAN1
P1 LAN2
P2 LAN2
BMC
i350 LAN
i350 LAN
P1-JBR1
P2-JBR1
1
2
VGA Enable/Disable
Jumpers P1-JPG1/P2-JPG1 allow the user to enable onboard VGA support for Node 1 (P1-
JPG1) or Node 2 (P2-JPG1). Refer to the table below for jumper settings.The default setting
is Enabled.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
CMOS Clear
P1-JBT1 is used to clear the saved system setup configuration stored in the CMOS chip for
Node 1, while P2-JBT1 is used for Node 2. To clear the contents of the CMOS, completely
shut down the system, remove the AC power cord connection, and then short P1-JBT1 or
P2-JBT1 with a jumper. Remove the jumper before powering on the system again. This will
erase all user settings and revert everything to their factory-set defaults.
Note:
Be sure to completely shut down the system, and then short JBT1 to clear the
CMOS.
1. CMOS Clear (Node 1)
2. CMOS Clear (Node 2)
3. VGA Enable/Disable (Node 1)
4. VGA Enable/Disable (Node 2)
3
4