Chapter 5: Advanced Motherboard Setup
5-9
5-8
SUPERSTORAGESYSTEM SSG-2028R-DN2R48L User's Manual
Removing the CPU and the Heatsink
Warning:
We do not recommend that the CPU or the heatsink be removed. However,
if you do need to uninstall the CPU or the heatsink, please follow the instructions below
to uninstall the heatsink or the CPU without damaging the CPU or the motherboard.
1. Unscrew the heatsink screws from the motherboard in the sequence as
shown in the illustration below.
2. Gently wriggle the heatsink to loosen it from the CPU socket. Do not use
excessive force when loosening the heatsink!
3. Once the heatsink is loosened, remove the it from the socket. Once the
heatsink is removed, remove the CPU from the socket as needed.
4. Remove the used thermal grease and clean the surface of the CPU and the
heatsink. Reapply the proper amount of thermal grease on the surface before
reinstalling the CPU and the heatsink as needed.
Note 1:
To optimize airflow, please follow your chassis airflow direction to properly
install the heatsink.
Note 2:
Graphics shown in this manual are for reference only. They may or may
not look the same as the components installed in your system.
Loosen screws in
the sequence as
shown
Screw#2
Motherboard
Screw#1
Screw#3
Screw#4
Direction of the
Airflow
5-5 Installing Memory
Note
: Check Supermicro's website for a list of recommended memory modules.
Caution:
Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMMA1. For best performance, please use DIMM modules of the same type
and speed in the same bank.
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
Figure 5-3. Installing DIMMs
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points at
each side of the slot.
5. With your thumbs, press the notches on both ends of the module straight
down into the slot until the module snaps into place.
6. Press the release tabs to their locking positions to secure the DIMM into the
slot.
Press both notches straight down
into the memory slot at the same
time.
Release Tabs
Notches
IPMI CODE
SAN MAC
BAR CODE
MAC CODE
BIOS
LICENSE
X10DSN-TS
Rev. 1.00
Summary of Contents for SuperStorageSystem SSG-2028R-DN2R48L
