Supermicro SuperStorageSystem SSG-2028R-DN2R48L, User Manual

Page: 17 / 85

Chapter 2: Server Installation
13 12
SUPERSTORAGESYSTEM SSG-2028R-DN2R48L User's Manual
Figure 2-10. Installing the Connectors 3 and 4
Figure 2-11. Routing the Cables
3. Slide CMA connector #3 forward onto the two posts on the rear of the left
middle rail. It snaps into place.
4. For CMA connector #4, align the metal tabs with the slots on the rear of the
left outer rail and push it forward. It snaps into place.
5. Open the six red plastic caps and route the cables into the wire carrier.
6. Use the six Velcro straps to secure the cables to the CMA. Use a strap on
either side of each joint and one on each connector.
7. Slide the chassis forward and backward in the rack to confirm that the cable
management arm is operating smoothly.
1
3
1
4
If at some time you must remove the cable management arm, follow this procedure.
Removing the Cable Management Arm
1. Remove cables from the CMA, releasing the Velcro straps and the red plastic
caps.
2. For CMA connector #4, pull the metal release tab toward the center of the
rack and slide the connector toward the rear to release it.
3. For CMA connectors #3, #2, and #1, depress the front edge of the yellow
plastic rocker lock, and slide the connector toward the rear to release it.